Your Ad Here

Use resin cutting blades to pay attention to 4 details

In order to be able to achieve safe production and increase production efficiency, some details of the use of the resin standard cut off wheel for metalrequire special attention:

1. When the cutting is not sharp, the cutting piece should be trimmed and edged. If it continues to be used, it will cause overheating and overload, and the cutting piece will be damaged. Also, it should be noted that the cutting piece is strictly prohibited for operations other than grooving or cutting, and abnormality due to uneven force is avoided.

Guaranteed Best Prices on Domains and Hosting!!!

2. In the rotation of the cutting piece, it is strictly forbidden to cut by hand, and the cutting piece cannot be touched by hand or body. Also, if abnormalities are found during the cutting process, stop immediately. Also note that when the cutting piece is marked with the direction of rotation, it must be in the same direction as the machine tool. On the contrary, the cutting is not sharp, and it is difficult to exert the performance of the cutting piece.

3. If a cutting piece that does not match the cut workpiece is used, it is prone to abnormal wear, poor sharpness, abnormal heat, and the like. In addition, it should be noted that when the flange is too small or the precision is poor, the cutting piece is easily damaged. Please use it after improvement.

4. Please check carefully before installing the cutting piece to confirm whether the cutting piece has deformation, crack, and collapse.
When using the resin dicing sheet, as long as you pay attention to the points mentioned above, there will be no major problems.

Leave a Response

You must be logged in to post a comment. Your Ad Here