Your Ad Here

Maintenance and Repair of Electromagnetic Construction Waste Crusher

Guaranteed Best Prices on Domains and Hosting!!!

1. Maintenance of electromagnetic construction waste crusher
(1) Periodically check whether screws in all parts loose or fall off.
(2) Regularly inspect whether clearance changes, dirt deposits seriously, or spring plate fractures.
(3) It is not allowed to empty feed bin in order to prevent material impacting to the trough.
(4) Controller should be placed in dustless, dry, low-temperature and good-ventilation position, and dust should be cleaned frequently. If working in high-temperature environment for a long time, it is necessary to set a fan for heat dissipation.
(5) If iron core and armature have crash, please take immediate overhaul.
(6) As for electric equipment, check whether the wiring of electromagnetic construction waste crusher in control box is loose or falloff; if find any mobility, please connect and tighten it according to the principle diagram. Check the thyrsi tor thread between shell and heat sink and tighten it, so that the rectifier keep good heat dissipation.
2. Repair of electromagnetic construction waste crusher
(1) When replace spring steel of electromagnetic construction waste crusher, please use 4pieces of top wires on both sides of chassis to tighten connecting fork, and fix connecting fork in correct position.
After replacement, loosen these screw sand lock back cap, then start the machine; re-tune the machine, and confirm replaced spring steel plate has same specifications with the original one.
(2) Tuning: mount spring steel according to the original number and tighten three big top threads so that elastic system close to the design requirements.
Tune the air gap between iron core and armature, and spring plate group according to the method mentioned in section Adjustment and Commissioning.
Under the rated voltage and power flow, and the amplitude within the scope of 1.750.2 mm, we can tighten or loosen top threads to make amplitude reach1.75 mm.
If amplitude is slightly big, please tighten the top threads; if small, unscrew them within a third ring.

Tagged as:

Leave a Response

You must be logged in to post a comment. Your Ad Here