Your Ad Here

vertical roller mill production process

The finishing area of ​​the coating polished clean, and then in the side panels and stiffeners coated primer, are coated on both sides of the stiffener placed inside the sieve, and try to install more bolts, stiffeners will weld Repair area on both sides of the cover, and then in order to ensure the smooth production of vertical roller mill, the need to tighten the bolts, the reinforcement board to drill a number of holes to ensure that cracks are covered, the hole into the riveting bolts tight;

Grind the weld outside the sieve, try to polish the weld less, as long as the weld clean, and the exposed side of the base metal can be, and then welding the same as the inside, the outer side of the plate polished smooth, the top of the side plate The holes on the welds ensure that all burrs have been removed and that there are no furrows and indentations to reduce this defect to assist in the fine grading of the material for the production process;

Guaranteed Best Prices on Domains and Hosting!!!

Polishing the repair area at the top of the side plate, polish the inner side of the angle steel and the side plate, add a stiffener to the inside angle and at least three riveted bolts on both sides of the weld. When all the riveted bolts are riveted on , Apply a paint over the repair area;

For the vertical roller mill production process, although the screeb is only an auxiliary equipment, but it is also an indispensable part of the production, so when working for the phenomenon of cracking the side panels, the need for timely processing, the above Given several treatment options, it can be seen from these options that these solutions are simple and time-saving and that the treated sieve does not crack for a long period of time, With high feasibility and reliability.

Tagged as: , ,

Leave a Response

You must be logged in to post a comment. Your Ad Here